f
Neutrium
Donate
Contact
Podcast
Articles

Neutrium Articles

Tag: Friction Factor


Flow in Open Channels and Partially Filled Pipes
Flow in Open Channels and Partially Filled Pipes

The transport of fluid under gravity is often achieved using partially filled pipes, channels, flumes, ditches and streams. To determine the slope and elevation change required or the flow rate that is achievable one must be able to calculate the head loss and friction factor. This article provides relationships for the calculation of head loss and friction factor for fluids flowing via these conduits.


Absolute Roughness of Pipe Material
Absolute Roughness of Pipe Material

Absolute roughness is a measure of the surface roughness of a material which a fluid may flow over. Absolute roughness is important when calculating pressure drop particularly in the turbulent flow regime. This article provides some typical absolute roughness values for common conduit materials.


Friction Factor for Flow in Coils and Curved Pipe
Friction Factor for Flow in Coils and Curved Pipe

In order to determine the pressure drop in a pipe or coil the friction factor must first be calculated. This article presents the equations which may be used to determine the friction factor in coils and curved pipe.


Pressure Loss in Pipe
Pressure Loss in Pipe

To determine the pressure loss or flow rate through pipe knowledge of the friction between the fluid and the pipe is required. This article describes how to incorporate friction into pressure loss or fluid flow calculations. It also outlines several methods for determining the Darcy friction factor for rough and smooth pipes in both the turbulent and laminar flow regime. Finally this article discusses which correlation for pressure loss in pipe is the most appropriate.